A tolerance is a cost, not a quality statement. The question is never “how tight can you hold it” but “how tight does this feature actually need to be”.

Where the cost sits

Going from ±0.1 mm to ±0.05 mm usually costs a slower finishing pass and a sample check. Going to ±0.01 mm adds a temperature-controlled environment, a CMM inspection and a rejection rate that someone has to pay for. The jump from 0.05 to 0.01 is not twice as expensive — it is often four or five times.

Surface finish

Ra 3.2 µm is the normal result of a finishing pass. Ra 1.6 µm needs a finer stepover and a sharper tool. Ra 0.8 µm and below usually means grinding or lapping as a second operation. Specify the finish on the face that seals, slides or is measured — not on the whole part.

How to write it on a drawing

Put the general tolerance in the title block, then call out exceptions individually. A drawing with ±0.01 mm in the title block and no exceptions is a sign that nobody has thought about which features matter.