Most of the cost in a machined part is decided before the drawing reaches a machine shop. Four features account for the difference between a part that quotes at one price and the same part quoting at three times that.

Wall thickness

A thin wall is not hard to cut. It is hard to hold. Below about 1 mm in aluminium, the wall deflects under cutting force and springs back after the finishing pass, so the measured thickness depends on where you measure it. Design for 1.5 mm where the function allows, and expect the quote to rise sharply below 1 mm.

Internal corner radius

A pocket is cut with a rotating tool, so every internal corner carries the radius of that tool. A 0.5 mm corner radius in a 40 mm deep pocket needs a long, slender tool that must run slowly to avoid chatter. State the largest radius the function allows — usually 3× the depth is the practical limit for a standard end mill.

Tolerance callouts

A general tolerance block covers most features. Adding ±0.01 mm to a dimension that does not need it adds inspection time, slower cutting and a higher scrap risk, and buys nothing. Call out tight tolerance only where the part interfaces with something.

Hole depth

A drilled hole is practical to about 5× its diameter, and 10× requires a peck cycle and a longer tool. Deeper than that, the hole wanders and the drill breaks. If the design needs a deep hole, consider whether it can be drilled from both ends or whether a different process serves better.

What to send with the drawing

Material grade, finish, quantity and target date. A drawing without a quantity cannot be quoted properly, because the setup cost per piece depends entirely on the batch size.