Silicone and TPE are both soft, both moldable and both quoted per project. They are not interchangeable, and the difference shows up in service rather than in the sample.

Temperature

Silicone holds from about -60 °C to 200 °C continuously. TPE softens above roughly 90 °C and becomes brittle below -40 °C. Anything near an engine, a heater or a sterilisation cycle is silicone territory.

Compression set

A seal that stays compressed for years needs low compression set. Silicone holds up far better than TPE in a static seal, which is why gaskets are usually silicone even when the surrounding part is not.

Cost and processing

TPE is cheaper per kilogram and can be overmolded onto a rigid plastic in the same cycle, which silicone cannot do without a primer and a separate step. For a grip or a bumper, TPE usually wins on price.

How to decide

If the part seals, sits under a bonnet, or has to survive cleaning at temperature, use silicone. If it is a grip, a cover or a cosmetic trim at room temperature, TPE is cheaper and easier to bond.