Case Study · Plastic Molding
Molded Plastic Enclosure
A two-part ABS enclosure with a gasket groove molded into the lid and a silicone seal quoted on the same order.

Problem
The prototype process did not scale
The enclosure and the seal came from two suppliers. When the lid leaked, neither would accept responsibility for the groove depth.
Approach
DFM first, then a four-cavity tool
Both parts were quoted together, with the groove depth and the seal section treated as one tolerance stack. First articles were fitted together before either production run was released.
- Groove depth measured on first article
- Seal section checked against the groove
- Assembly fit test with the mating half
- Texture and colour against the approved sample
Result
Unit cost below the target
Quoting the two parts as one stack removed the argument. The customer now orders enclosure, seal and screws as a single kit.
Drawings and customer name stay confidential.
More projects
Related case studies
Silicone Mask Component
Compression-molded mask part with a soft sealing lip and documented compound traceability.
View Case Study
Turned Stainless Component
Thin-wall turned part where wall thickness and run-out decided the process route.
View Case Study
Automation Fixture Bracket
Bracket machined from solid, flatness and hole position held for a locating fixture.
View Case StudyReady to Start Your Precision Component Project?
Send us your drawing and requirements for an engineering review and quotation.