Case Study · Compression Molding
Silicone Mask Component
A soft silicone mask component with a thin sealing lip, molded in a medical-grade compound with batch traceability.
Problem
Below the limit of the old tool
The sealing lip is thin and the part is thick — a combination that is hard to fill without flash or voids. Batch hardness also drifted between deliveries.
Approach
LSR, steel tool, colour approved first
Tool temperature and cure time were set per section thickness, and hardness is checked on every batch against the approved sample rather than against the nominal value only.
- Hardness check per batch
- Flash and void inspection
- Compound certificate per lot
- Sample retained for traceability
Result
Short-shots eliminated
The part now runs on a fixed tool with a documented cure recipe, and hardness variation is inside the customer’s incoming inspection tolerance.
Drawings and customer name stay confidential. Medical-grade documentation is quoted per project.
More projects
Related case studies

Molded Plastic Enclosure
Two-part ABS enclosure with a gasket groove molded in, matched to a silicone seal.
View Case Study
Turned Stainless Component
Thin-wall turned part where wall thickness and run-out decided the process route.
View Case Study
Automation Fixture Bracket
Bracket machined from solid, flatness and hole position held for a locating fixture.
View Case StudyReady to Start Your Precision Component Project?
Send us your drawing and requirements for an engineering review and quotation.